01 Design
You
I’m designing the next version of an electrochemical cell that pulls lithium out of brine, with two electrodes facing each other. If I tighten the gap between them, what do I gain and what do I risk?
Claude
In general, a tighter gap cuts the cell’s resistance and so its voltage, and raises the risk of shorts, uneven flow, and gas or deposits bridging the gap. I can’t see your drawings or your earlier cells’ test runs, so I can’t tell you where your gap should sit.
01 Design
You
I’m designing the next version of an electrochemical cell that pulls lithium out of brine, with two electrodes facing each other. If I tighten the gap between them, what do I gain and what do I risk?
Claude
In general, a tighter gap cuts the cell’s resistance and so its voltage, and raises the risk of shorts, uneven flow, and gas or deposits bridging the gap. I can’t see your drawings or your earlier cells’ test runs, so I can’t tell you where your gap should sit.
02 Operations
You
Our electrochemical extraction unit is running in the field. How do I trace which cell build, and which pre-ship test results, went into each of its stacks?
Claude
Usually you’d keep a record that ties each stack’s serial to its cells’ build and test records, then join the unit’s run data to it. I can’t see your run data or those records, so I can’t tell you which build is in which stack.
02 Operations
You
Our electrochemical extraction unit is running in the field. How do I trace which cell build, and which pre-ship test results, went into each of its stacks?
Claude
Usually you’d keep a record that ties each stack’s serial to its cells’ build and test records, then join the unit’s run data to it. I can’t see your run data or those records, so I can’t tell you which build is in which stack.
At the frontier of science & engineering, agents need verified tools & information.
“Harness engineering” is how we connect LLM intelligence with company-specific tools & information.
Claude ×
What’s the most likely way a chromium electrode feedthrough fails under repeated thermal cycling, and how should we test for it?
Most likely, the scale is what fails: cycling cracks the Cr₂O₃, and contact resistance climbs. A standard thermal-shock test on the bare electrode will show it.I can’t tell which failure mode matters most without your design. If you can share how your feedthrough is clamped and your thermal-cycling results, I can weigh in on what to test.
That’s not how ours are built.
Claude ×
What’s the most likely way a chromium electrode feedthrough fails under repeated thermal cycling, and how should we test for it?
Most likely, the scale is what fails: cycling cracks the Cr₂O₃, and contact resistance climbs. A standard thermal-shock test on the bare electrode will show it.I can’t tell which failure mode matters most without your design. If you can share how your feedthrough is clamped and your thermal-cycling results, I can weigh in on what to test.
That’s not how ours are built.